N.Y.C. Admin. Code § FC 2106: Section FC 2106: Spotting and Pretreating

2106.1 General.

The storage, handling and use of dry cleaning solvents for spotting and pretreating operations in any dry cleaning facility shall comply with the requirements of this section, based on the classification of the solvent.

2106.2 Class I solvents.

The maximum quantity of Class I solvents allowed at any dry cleaning facility shall be 1 gallon (4 L). Class I solvents shall be stored in approved metal containers or safety cans of not more than 2 quarts (2 L) capacity.

2106.3 Class II and III solvents.

Spotting and pretreating, including scouring and brushing, shall be conducted with Class II or III solvents. The maximum quantity of Class II or III solvents allowed at any work station shall be 1 gallon (4 L). In an occupancy other than a Group H-2 occupancy, the aggregate quantities of solvents shall not exceed the maximum allowable quantity per control area for use-open systems.

2106.3.1 Spotting tables.

Scouring, brushing or spotting tables on which items are soaked in solvent shall have a liquid-tight top with a curb on all sides not less than 1 inch (25 mm) high. The top of the table shall be pitched to ensure thorough draining to a 1 1/2-inch (38-mm) drain connected to an approved container.

2106.3.2 Special handling.

Items that may be damaged from being washed in the washing equipment may be manually cleaned in scrubbing tubs. Scrubbing tubs shall comply with the following requirements:

1. Only Class II or III liquids shall be used.

2. The total amount of solvent used in such tubs shall not exceed 3 gallons (11 L).

3. Scrubbing tubs shall be secured to the floor.

4. Scrubbing tubs shall be provided with permanent 1 1/2-inch (38-mm) drains. Such drains shall be provided with a trap and shall be connected to an approved container.

2106.3.3 Ventilation.

Scrubbing tubs, scouring, brushing or spotting operations shall be located such that solvent vapors are captured and exhausted by the ventilating system.

2106.3.4 Bonding and grounding.

Metal scouring, brushing and spotting tables and scrubbing tubs shall be permanently and effectively bonded and grounded.

2106.4 Reserved.

2106.5 Prohibited spotting and pretreating operation.

It shall be unlawful to store, handle or use any Class I, Class II or Class III solvent for spotting or pretreating operations in any Type V dry cleaning facility or in connection with the use of any Type V dry cleaning system.