9VAC5-40-4040: Control technology guidelines

A. Sheet basecoat (exterior and interior) and overvarnish; two-piece can exterior (basecoat and overvarnish). The control technology should consist of one or more of the following:

1. Use of electrodeposited waterborne coatings;

2. Use of ultraviolet coatings;

3. Use of high solids coatings;

4. Carbon adsorption; and

5. Incineration; or

6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 A 1, provided such technology is approved by the board.

B. Two-piece and three-piece can interior body spray; two-piece can exterior end (spray or roll coat). The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of powder coatings;

3. Use of high-solids coatings;

4. Carbon adsorption; and

5. Incineration; or

6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 B 1, provided such technology is approved by the board.

C. Three-piece can side-seam spray. The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of powder coatings; and

3. Use of high solids coatings; or

4. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 C 1, provided such technology is approved by the board.

D. End sealing compound coating. The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of high-solids coatings; or

3. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 D 1, provided such technology is approved by the board.