9VAC5-40-7800: Applicability and designation of affected facility

Article 53

Emission Standards for Lithographic Printing Processes (Rule 4-53)

A. Except as provided in subsections C, D, and E of this section, the affected facility to which the provisions of this article apply is each lithographic printing process that uses a substrate other than a textile.

B. The provisions of this article apply only to sources of volatile organic compounds in volatile organic compound emissions control areas designated in 9VAC5-20-206.

C. Exempted from the provisions of this article are offset lithographic printing operations in the Northern Virginia Volatile Organic Compound Emissions Control Area. Provisions applicable to offset lithographic printing operations in the Northern Virginia Volatile Organic Compound Emissions Control Area are provided in Article 56.1 (9VAC5-40-8420 et seq.) of this part.

D. Exempted from the provisions of this article are facilities in all volatile organic compound emissions control areas, other than the Northern Virginia Volatile Organic Compound Emissions Control Area, whose potential to emit is less than 100 tons per year of volatile organic compounds, provided the emission rates are determined in a manner acceptable to the board. All volatile organic compound emissions from printing inks, coatings, cleaning solutions, and fountain solutions shall be considered in applying the exemption levels specified in this subsection.

E. The provisions of this article do not apply to the following:

1. Printing processes used exclusively for determination of product quality and commercial acceptance provided:

a. The operation is not an integral part of the production process;

b. The emissions from all product quality printing processes do not exceed 400 pounds in any 30-day period; and

c. The exemption is approved by the board.

2. Photoprocessing, typesetting, or imagesetting equipment using water-based chemistry to develop silver halide images.

3. Platemaking equipment using water-based chemistry to remove unhardened image-producing material from an exposed plate.

4. Equipment used to make blueprints.

5. Any sheet-fed offset lithographic press with a cylinder width of 26 inches or less.