GroundRules
16 CFR 1201.5: Certification and labeling requirements.
Where this section sits in the code
- Title 16—Commercial Practices
- CHAPTER II—CONSUMER PRODUCT SAFETY COMMISSION
- SUBCHAPTER B—CONSUMER PRODUCT SAFETY ACT REGULATIONS
- PART 1201—SAFETY STANDARD FOR ARCHITECTURAL GLAZING MATERIALS
- Subpart A—The Standard
(a) Manufacturers and private labelers of glazing materials covered by this part 1201 shall comply with the requirements of section 14 CPSA (15 U.S.C. 2063) and regulations issued under section 14.
(b) [Reserved]
(c) Organic-coated glass that has been tested for environmental exposure from one side only must bear a permanent label on the coating stating “GLAZE THIS SIDE IN” and shall bear in the central 50 percent of the surface area the following message in letters at least 1/4 inch (7 millimeters) high: “SEE PERMANENT LABEL FOR IMPORTANT MOUNTING INSTRUCTION.” The latter message shall be attached to either side of the glazing by any means which shall ensure the message will remain in place until installation.
Collected 2026-08-27T02:24:29Z. Source file · JSON