Federal regulations · Through 2026-08-25 · Newer source version available

40 CFR 1090.910: Reports by gasoline manufacturers that recertify BOB to gasoline.

A gasoline manufacturer that recertifies BOB under § 1090.740 must report the information of this section, as applicable
(a) Batch reporting. (1) A party that recertifies a BOB under § 1090.740 with less oxygenate than specified by the BOB manufacturer must report the following for each batch:
(i) The EPA-issued company and facility identifiers for the recertifying party.
(ii) The batch number assigned by the recertifying party.
(iii) The date the batch was recertified.
(iv) The batch volume, as a negative number in gallons. The volume is the amount of oxygenate that the recertifying gasoline manufacturer did not blend with the BOB.
(v) The designation of the batch.
(vi) A sulfur content of 11 ppm.
(vii) A benzene content of 0.68 volume percent.
(viii) The type and content of each oxygenate, as a volume percentage.
(ix) The sulfur deficit for the batch calculated under § 1090.740(b)(2).
(x) The benzene deficit for the batch calculated under § 1090.740(b)(4).
(2) A party that recertifies a BOB under § 1090.740 with more oxygenate than specified by the BOB manufacturer does not need to report the batch.
(b) Annual sulfur and benzene compliance reporting. A party that recertifies a BOB under § 1090.740 must include any deficits incurred from recertification in reports under § 1090.905(a) and (b).
(c) Credit transactions. A party that recertifies a BOB under § 1090.740 must report any credit transactions under § 1090.905(d).

Where this section sits in the code

Title 40—Protection of Environment
CHAPTER I—ENVIRONMENTAL PROTECTION AGENCY
SUBCHAPTER U—AIR POLLUTION CONTROLS
PART 1090—REGULATION OF FUELS, FUEL ADDITIVES, AND REGULATED BLENDSTOCKS
Subpart J—Reporting

A gasoline manufacturer that recertifies BOB under § 1090.740 must report the information of this section, as applicable

(a) Batch reporting. (1) A party that recertifies a BOB under § 1090.740 with less oxygenate than specified by the BOB manufacturer must report the following for each batch:

(i) The EPA-issued company and facility identifiers for the recertifying party.

(ii) The batch number assigned by the recertifying party.

(iii) The date the batch was recertified.

(iv) The batch volume, as a negative number in gallons. The volume is the amount of oxygenate that the recertifying gasoline manufacturer did not blend with the BOB.

(v) The designation of the batch.

(vi) A sulfur content of 11 ppm.

(vii) A benzene content of 0.68 volume percent.

(viii) The type and content of each oxygenate, as a volume percentage.

(ix) The sulfur deficit for the batch calculated under § 1090.740(b)(2).

(x) The benzene deficit for the batch calculated under § 1090.740(b)(4).

(2) A party that recertifies a BOB under § 1090.740 with more oxygenate than specified by the BOB manufacturer does not need to report the batch.

(b) Annual sulfur and benzene compliance reporting. A party that recertifies a BOB under § 1090.740 must include any deficits incurred from recertification in reports under § 1090.905(a) and (b).

(c) Credit transactions. A party that recertifies a BOB under § 1090.740 must report any credit transactions under § 1090.905(d).

Collected 2026-08-27T02:26:04Z. Source file · JSON

Browse this collection