Skip to content

← Search the law

Federal regulations · Through 2026-08-25 · Newer source version available

40 CFR Table 8 to Subpart XXXX of Part 63: Table 8 to Subpart XXXX of Part 63—Initial Compliance With the Emission

Read at publisher ↗

As stated in § 63.6002, you must show initial compliance with the emission limits for puncture sealant application affected sources according to the following table:
For . . . For the following emission limit . . . You have demonstrated initial compliance if . . .
1. Sources complying with the overall control efficiency alternative in § 63.5989(a) The percent reduction option in table 3 to this subpart, option 1 You demonstrate that you conducted the performance tests, determined the overall efficiency of your control system, demonstrated that the applicable limits in table 3 to this subpart, option 1, have been achieved, and established the operating limits in table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b).
2. Sources complying with the permanent total enclosure and control device efficiency alternative in § 63.5989(b) The percent reduction option in table 3 to this subpart, option 1 You demonstrate that you conducted the performance tests, determined the individual efficiencies of your capture and control systems, demonstrated that the applicable limits in table 3 to this subpart, option 1, have been achieved, and established the operating limits in table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b).
3. Sources complying with the monthly average alternative in § 63.5989(c) without using an add-on control device The HAP constituent option in table 3 to this subpart, option 2 You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c) and (d)(1).
4. Sources complying with the HAP constituent alternative in § 63.5989(d) by using an add-on control device The HAP constituent option in table 3 to this subpart, option 2 You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c), (d)(2) and (3), and (e) through (f).

Where this section sits in the code

Title 40—Protection of Environment
CHAPTER I—ENVIRONMENTAL PROTECTION AGENCY
SUBCHAPTER C—AIR PROGRAMS
PART 63—NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS FOR SOURCE CATEGORIES
Subpart XXXX—National Emissions Standards for Hazardous Air Pollutants: Rubber Tire Manufacturing

As stated in § 63.6002, you must show initial compliance with the emission limits for puncture sealant application affected sources according to the following table:

For . . . For the following emission limit . . . You have demonstrated initial compliance if . . .

1. Sources complying with the overall control efficiency alternative in § 63.5989(a) The percent reduction option in table 3 to this subpart, option 1 You demonstrate that you conducted the performance tests, determined the overall efficiency of your control system, demonstrated that the applicable limits in table 3 to this subpart, option 1, have been achieved, and established the operating limits in table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b).

2. Sources complying with the permanent total enclosure and control device efficiency alternative in § 63.5989(b) The percent reduction option in table 3 to this subpart, option 1 You demonstrate that you conducted the performance tests, determined the individual efficiencies of your capture and control systems, demonstrated that the applicable limits in table 3 to this subpart, option 1, have been achieved, and established the operating limits in table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b).

3. Sources complying with the monthly average alternative in § 63.5989(c) without using an add-on control device The HAP constituent option in table 3 to this subpart, option 2 You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c) and (d)(1).

4. Sources complying with the HAP constituent alternative in § 63.5989(d) by using an add-on control device The HAP constituent option in table 3 to this subpart, option 2 You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c), (d)(2) and (3), and (e) through (f).

Collected 2026-08-27T02:26:04Z. Source file · JSON

Browse this collection