GroundRules
49 CFR 179.500-5: -5 Material.
Where this section sits in the code
- Title 49—Transportation
- Subtitle B—Other Regulations Relating to Transportation
- CHAPTER I—PIPELINE AND HAZARDOUS MATERIALS SAFETY ADMINISTRATION, DEPARTMENT OF TRANSPORTATION
- SUBCHAPTER C—HAZARDOUS MATERIALS REGULATIONS
- PART 179—SPECIFICATIONS FOR TANK CARS
- Subpart F—Specification for Cryogenic Liquid Tank Car Tanks and Seamless Steel Tanks (Classes DOT-113 and 107A)
(a) Tanks shall be made from open-hearth or electric steel of uniform quality. Material shall be free from seams, cracks, laminations, or other defects injurious to finished tank. If not free from such defects, the surface may be machined or ground to eliminate these defects. Forgings and seamless tubing for bodies of tanks shall be stamped with heat numbers.
(b) Steel (see Note 1) must conform to the following requirements as to chemical composition:
Designation Class I (percent) Class II (percent) Class III (percent)
Carbon, maximum 0.50 0.50 0.53
Manganese, maximum 1.65 1.65 1.85
Phosphorus, maximum .05 .05 .05
Sulphur, maximum .06 .05 .05
Silicon, maximum .35 .30 .37
Molybdenum, maximum .25 .30
Chromium, maximum .30 .30
Sum of manganese and carbon not over 2.10 2.10
Note 1: Alternate steel containing other alloying elements may be used if approved.
(1) For instructions as to the obtaining and checking of chemical analysis, see § 179.500-18(b)(3).
(2) [Reserved]
Collected 2026-08-27T02:26:34Z. Source file · JSON