Federal regulations · Through 2026-08-25 · Newer source version available

40 CFR 463.14: New source performance standards.

Where this section sits in the code

Title 40—Protection of Environment
CHAPTER I—ENVIRONMENTAL PROTECTION AGENCY
SUBCHAPTER N—EFFLUENT GUIDELINES AND STANDARDS
PART 463—PLASTICS MOLDING AND FORMING POINT SOURCE CATEGORY
Subpart A—Contact Cooling and Heating Water Subcategory

(a) NSPS for bis(2-ethylhexyl) phthalate are reserved.

(b) Any new source subject to this subpart must achieve performance standards (i.e., mass of pollutant discharged), which are calculated by multiplying the average process water usage flow rate for the contact cooling and heating water processes at a new source times the following pollutant concentrations:

Subpart A

[Contact cooling and heating water]

Concentration used to calculate NSPS

Pollutant or pollutant property Maximum for any 1 day (mg/l)

BOD5 26

Oil and grease 29

TSS 19

pH (1)

1 Within the range of 6.0 to 9.0 at all times.

The permit authority will obtain the average process water usage flow rate for the new source contact cooling and heating water processes from the permittee.

Collected 2026-08-27T02:26:04Z. Source file · JSON

Browse this collection