GroundRules
40 CFR Table 3 to Subpart KKKK of Part 63: Table 3 to Subpart KKKK of Part 63—Emission Limits for Affected Sources Using the Control Efficiency/Outlet Concentration Compliance Option
Where this section sits in the code
- Title 40—Protection of Environment
- CHAPTER I—ENVIRONMENTAL PROTECTION AGENCY
- SUBCHAPTER C—AIR PROGRAMS
- PART 63—NATIONAL EMISSION STANDARDS FOR HAZARDOUS AIR POLLUTANTS FOR SOURCE CATEGORIES
- Subpart KKKK—National Emission Standards for Hazardous Air Pollutants: Surface Coating of Metal Cans
You must comply with the emission limits that apply to your affected source in the following table as required by § 63.3490(d).
If you use the control efficiency/outlet concentration option to comply with the emission limitations for any coating operation(s) . . . Then you must comply with one of the following by using an emissions control system to . . .
1. in a new or reconstructed affected source a. reduce emissions of total HAP, measured as THC (as carbon), a by 97 percent; or b. limit emissions of total HAP, measured as THC (as carbon), a to 20 ppmvd at the control device outlet and use a PTE.
2. in an existing affected source a. reduce emissions of total HAP, measured as THC (as carbon), a by 95 percent; or b. limit emissions of total HAP, measured as THC (as carbon), a to 20 ppmvd at the control device outlet and use a PTE.
a You may choose to subtract methane from THC as carbon measurements.
Collected 2026-08-27T02:26:04Z. Source file · JSON